• PRODUCTS
  • Pavement Sealers
  • Sealer Additives
  • Crack Fillers
  • Preparation & Repair
  • Traffic Paints
  • Concrete Products
  • Dust Suppressant
  • Equipment
  • Tools & Accessories
  • Sport Surfacing

• TECHNICAL INFO
  • Specifications
  • Engineering Specs
  • MSDS
  • Certificates
  • Pavement Maintenance 101

• RESOURCES
  • Credit Application
  • Tank Calculator
  • Classifieds

Sealcoating Products

SealMaster®
E-Z Stir Pavement Sealer

The Sealer That's Ready-To-Use! Simply stir, pour, and apply by squeegee, brush, or spray!

Sizes Available
5 Gallon Pail, 55 gallon Drum

Coverage
One gallon of E-Z Stir Pavement Sealer will cover approximately 70-82 sq. ft. (7.8 to 9.1 sq. yards) per coat when properly mixed and applied.

NOTE: Coverage rate may vary due to pavement age, porosity, and method of application.

MSDS Sheet (PDF)

Specification Sheet (PDF)

Description
E-Z Stir is a ready to use asphalt emulsion pavement sealer fortified with silica sand for added wearability and slip resistance.

Advantages
• Ideal for maintenance crews and Do-It-Yourselfers
• Fortified with sand for slip resistance and durability

Surface Preparation
New asphalt surfaces must cure a minimum of four weeks under ideal weather conditions before application. Surface must be clean and free from all loose material, dirt, and dust. Cracks should be filled with SealMaster Hot Pour or Cold Applied crack fillers. Treat all grease, oil, and gasoline stains with SealMaster® Petro Seal or Prep Seal.

Mixing Procedures
Stir thoroughly before using. Do not dilute.

Application
Apply one or two coats of material. Apply by squeegee, brush or spray. Allow a minimum of 2 to 4 hours drying time before applying second coat. Allow 24 hours before parking cars or allowing traffic to resume.

Important
Temperatures must be above 50°F both during application and for aperiod of at least 24 hours after application. Do not apply when rain is imminent or forecast.

Clean Up
Wash tools in water before material dries.