SealMaster
SealMaster
Home Site Map Careers Log In
Literature Videos News Contact Us Locations Locate Installers
Choose Sealcoating Contractors Property Managers Road Maintenance Sport Surfacing Architects/Engineers Franchise Opportunities

 

 

Go Back To Products Page

Hot Pour Crack Fillers

CrackMaster™ Parking Lot Grade

A premium quality crack and joint sealing material that resists tracking at elevated temperatures and remains flexible down to -10°F. When melted and properly applied it forms a resilient crack sealant for both asphaltic and cementatious pavements. CrackMaster Parking Lot Grade forms a lasting seal that resists tracking in warm climates.

Sizes Available
50 lb. box with two 25 lb. cubes per box.

Coverage
Use the following chart as a guideline for estimating material requirements (based upon pounds of material needed for 100 feet of cracks):

Crack Width
Depth
.lbs/100 ft.
3/8"
3/8"
6.9 lbs.
1/2"
1/2"
12.3 lbs.
3/4"
3/4"
27.8 lbs.

The above coverage rates are only a guideline. Actual material usage may vary due to width of application and thickness of material above pavement surfaces.



MSDS Sheet PDF (PDF) Specification Sheet PDF (PDF)

Description
A premium quality crack and joint sealing material that resists tracking at elevated temperatures and remains flexible down to -10°F. When melted and properly applied it forms a resilient crack sealant for both asphaltic and cementatious pavements. CrackMaster™ Parking Lot Grade forms a lasting seal that resists tracking in warm climates.

Uses
CrackMaster™ Parking Lot Grade is designed to seal expansion joints, longitudinal and transverse cracks, joints between concrete and asphalt shoulders, and random cracks in both asphalt and concrete pavements. It is ideally suited for parking lots.

Mixing Procedures
Use material as supplied. Do not blend with other materials. After CrackMaster™ Parking Lot Grade is melted it should be agitated or recirculated.

Application
Apply heated CrackMaster™ Parking Lot Grade using either a pump and wand system or a pour pot. For best results the sealant depth to width ratio should not exceed 2 to 1 (i.e. 2-inches deep to 1-inch wide). The cooled sealant height should not exceed 1/8" above surrounding pavement. Using a sealing shoe or squeegee, band the material 2 to 3 inches wide over the crack.

Important
Protective apparel is recommended with application of CrackMaster™ Parking Lot Grade. The extremely hot material will cause severe burns on contact with skin. OSHA Safety Regulations require workers to wear the following types of safety attire (see current OSHA/Safety Regulations for additional information): Hard hat with face shield; long sleeved shirt buttoned at the wrist; heat resistant gloves; long, cuffless pants; and safety toed work boots. Make certain all area around melter is clear of all debris and flammable materials. Avoid breathing vapors. Use with adequate ventilation.

Clean Up
Wash tools in water before material dries.

 


Catalog
Unit Size Unit Weight
View In Catalog 50 lb. box 50 lbs.
  Spacer SealMaster Catalog SealMaster Catalog
Bar
SealMaster Locations
Bar
SealMaster Franchise Opportunities
Bar


Untitled Document
ProductsTechnical InfoResourcesLiteratureVideosNewsContact UsCatalogLocationsLocate Installers
Sealcoating ContractorProperty ManagerRoad MaintenanceSport SurfacingArchitect/EngineerFranchise Opportunities
HomeSite MapCareersLog In


Copyright © 2012 SealMaster,
All Rights Reserved