|
Description
SealMaster® Coal Tar Sealer is a coal tar emulsion sealer designed to protect and beautify asphalt pavement surfaces.
Advantages
• Deep, Rich Black Color
• Oil and Fuel Resistant
• Reduced Fume Formulation For User Friendly Application
Surface Preparation
New asphalt surfaces must cure a minimum of four weeks under ideal weather conditions before application. Surface must be clean and free from all loose material, dirt, and dust. Cracks should be filled with SealMaster® Hot Pour or Cold Applied crack fillers. Treat all grease, oil, and gasoline stains with SealMaster® Petro Seal or Prep Seal.
Mixing Procedures
For optimum results, mix SealMaster® Pavement Sealer in accordance with the following mix design (based on 100 gallons for ease of calculation):
SealMaster® Coal Tar Pavement Sealer: 100 gallons
Water: 30 - 40 gallons
Sand: 300 - 500 lbs.
Mix materials to a uniform consistency.
NOTE: A polymer latex additive (such as TopTuff or Sealer V.M.) may be added at the rate of 1-2% based on undiluted gallons of Coal Tar Sealer. Or, Zetac may be added at the rate of 1-2%.
Application
Two coats of mixed material are recommended. Apply by squeegee, brush, or spray. Allow a minimum of 2 to 4 hours drying time before applying second coat. Allow 24 hours before parking cars or allowing traffic to resume.
Important
Temperatures must be above 50°F both during application and for aperiod of at least 24 hours after application. Do not apply when rain is imminent or forecast.
Clean Up
Wash tools in water before material dries. |
